پاک اسٹڈی لائبریری اپنی خدمات کو بہتر کرنے کے لئے نئے سوفٹ وئیر انسٹال کررہی ہے ۔ اس لئے آئندہ کچھ دن آپ کو کچھ صفحات تک رسائی میں مشکلات کا سامنا ہوسکتا ہے ۔ جس کے لئے ہم معذرت خواہ ہیں۔
Pak Study Library is installing new software to improve its services. herefore, in the next few days, you may face difficulties in accessing some pages. sorry for the inconvenience.
Which Of The Following Can Be Used To Create A Flow Of Gas, Where No Significant Compression Is Required ?
Centrifugal Compressor | |
Axial Flow Compressor | |
Reciprocating Compressor | |
Blower |
Which Of The Following Can Be Used For The Direct Measurement Of Volumetric Flow Rate Of Slurry ?
Orificemeter | |
Rotameter | |
Venturimeter | |
Pitot Tube |
Which Of The Following Assumptions Enables The Euler’S Equation Of Motion To Be Integrated ?
The Continuity Equation Is Satisfied | |
The Flow Is Rotational And Incompressible | |
The Fluid Is Incompressible | |
The Fluid Is Non-Viscous |
Which Of The Fluid Forces Are Not Considered In The Reynold’S Equation Of Flow ?
Viscous Forces | |
Pressure Forces | |
Compressibility Forces | |
Turbulent Forces |
Which Law/Principle Of Solid Mechanics Is Similar/Equivalent To Newton’S Law Of Viscosity In Fluid Mechanics ?
Newton’S Third Law Of Motion | |
Newton’S Second Law Of Motion | |
Archimedes Principle | |
Hooke’S Law |
Which Law Is Followed By The Velocity Distribution In The Turbulent Boundary Layer ?
Logarithmic Law | |
Linear Law | |
None Of These | |
Parabolic Law |
Which Is The Most Efficient And Best For Measuring Very Small Flow Rate Of Gases ?
Orificemeter | |
Rotameter | |
Flow Nozzle | |
Venturimeter |
Which Is The Correct Relationship For A Centrifugal Pump?
D = 1840 H0.5/N | |
H = 1840 D0.5/N | |
D = 1840 H/N | |
D = 1840 N/H0.5 |
Which Is Not A Variable Head Meter ---------?
Pitot Tube | |
None Of These | |
Venturimeter | |
Rotameter |
Where Does The Maximum Stress Occur In Case Of Laminar Flow Of Incompressible Fluid In A Closed Conduit Of Diameter ‘D’ ?
At The Wall | |
At D/8 From The Wall | |
At D/4 From The Wall | |
At The Centre |
When The Water Is Warm, The Height To Which It Can Be Lifted By A Pump---------?
Decreases Due To Reduced Viscosity | |
Decreases Due To Reduced Vapour Pressure | |
Decreases Due To Increased Frictional Resistance | |
Increases Due To Increased Vapour Pressure |
When The Pipe Reynold’S Number Is 6000, The Flow Is Generally-----------?
Viscous | |
Laminar | |
Transition | |
Turbulent |
When The Momentum Of One Fluid Is Used For Moving Another Fluid, Such A Device Is Called A/An----------?
Acid Egg | |
Jet Pump | |
None Of These | |
Blower |
When The Head Pumped Against Is Less Than The Head Of The Fluid Used For Pumping, The Usual Device Is A/An----------?
Injector | |
Ejector | |
Airlift | |
Blower |
When Larger Particles E.G., Grains Are Subjected To Fluidisation, The Corresponding Bed Produced Is Termed As The ----------- Bed?
Sluggish | |
Teeter | |
Spouted | |
Boiling |
When A Fluid Flows Over A Solid Surface, The-----------?
Resistance Between The Surface & The Fluid Is Lesser As Compared To That Between The Fluid | |
Velocity Gradient Is Zero At The Solid Surface | |
Velocity Is Uniform At Any Cross-Section | |
Layers Themselves |
What Type Of Motion The Fluid Element Undergoes, When It Changes From One Position To Another Position, Such That The Angle Between The Two Sides Change
Translation | |
Rotation | |
Angular Deformation | |
Linear Deformation |
What Is The Value Of Fanning Friction Factor F ‘ For Smooth Pipe At Nre = 106 Approximately ?
0.003 | |
0.1 | |
0.01 | |
0.3 |
What Is The Value Of Co-Efficient Of Discharge For Square Edged Circular Orifice (For Β = 0.3 To 0.5) ?
0.5 – 0.75 | |
0.35 – 0.55 | |
0.75 – 0.90 | |
0.61 – 0.63 |
What Is The Unit Of Kinematic Viscosity In Si Unit ?
M2/Sec | |
None Of These | |
N/M2. Sec | |
Kg. Sec/M |
What Is The Speed Of Sound (M/Sec) In Ordinary Water ?
3000 | |
1500 | |
330 | |
1000 |
What Is The Shear Rate At The Pipe Wall, In Case Of Laminar Flow Of Newtonian Fluids In A Pipe Of Diameter ‘D’ & Length ‘L’ Incurring A Pressure Dro
4 Vavg/D | |
D Δp/4l | |
8 Vavg/D | |
D Δp/8l |
What Is The Ratio Of Total Kinetic Energy Of Fluid Passing Per Second To The Value Obtained On The Basis Of Average Velocity (For Laminar Flow Through A
1 | |
1.5 | |
0.5 | |
2 |
What Is The Ratio Of The Velocity At The Axis Of The Pipe To The Mean Velocity Of Flow In Case Of Pipe Flow Under Viscous Condition ?
0.67 | |
2 | |
0.5 | |
1 |
What Is The Ratio Of Fluid Carrying Capacity Of Two Pipes Having Diameters D1 And D2 Respectively ?
(D1/D2)0.5 | |
(D1/D2)0.8 | |
D1/D2 | |
(D1/D2)2 |