Civil Engineering Mcqs

Function Of Air Vessel Provided In A Reciprocating Pump Is To---------?

Froude Number Is The Ratio Of----------?

Froude Number Is Not A Factor----------?

Friction Produced By The Formation Of Wakes Is Called The ---------- Friction?

Friction Factor For A Hydraulically Smooth Pipe At Nre = 2100 Is F1.

Forces Acting On A Particle Settling In Fluid Are --------- Forces?

For Water, When The Pressure Increases, The Viscosity---------?

For Very Low Pressure And High Discharge Rate, The Compressor Used Is A/An ---------- Compressor?

For Turbulent Fluid Flow In Pipe, The Expression For Prandtl One Seventh Power Law Is (Where, R = Pipe Radius, X = Distance) ?

For Turbulent Flow Of Newtonian Fluid In A Circular Cross-Section Pipe, The Ratio Of Maximum To Average Fluid Velocity Is --------?

For Turbulent Flow Of An Incompressible Fluid Through A Pipe, The Flow Rate „Q‟ Is Proportional To (Δ P)N, Where Δp Is The Pressure Drop.

For Turbulent Flow In Smooth Circular Pipe, The Velocity Distribution Is A Function Of The Distance ‘D’ Measured From The Wall Of The Pipe And The Frict

For The Transfer Of Solution Of Thick Slurry, The Pump Used Is A --------- Pump?

For The Same Terminal Conditions And Valve Size, The Pressure Drop In A Fully Opened Globe Valve As Compared To That In A Gate Valve Is-----------?

For The Same Terminal Conditions And Fitting Size, The Least Friction Loss Is Incurred In A/An ?

For The Same Flow Rate Of A Fluid, The Pressure Drop Is The Least For --------?

For The Production Of Very High Vacuum, A --------- Pump Is Normally Used?

For The Manometer Set Up Shown In The Figure, The Pressure Difference Pa – Pb Is Given By---------?

For The Laminar Flow Of A Fluid In A Circular Pipe Of Radius R, The Hagen-Poisseule Equation Predicts The Volumetric Flow Rate To Be Proportional To----

For The Free Settling Of A Spherical Particle Through A Fluid, The Slope Of, Cd-Log Nre, Plot Is--------?

For Steady Ideal Fluid Flow, The Bernoulli’S Equation States That The---------?

For Pipes That Must Be Broken At Intervals For Maintenance, The Connector Used Should Be A/An----------?

For Pipe Flows, Head Is Proportional To ---------- At Constant Capacity(Where, D = Pipe Diameter) ?

For One Dimensional Flow Of An Incompressible Fluid In Unsteady State In X-Direction, The Continuity Equation Is Given By-----------?

For Motion Of Spherical Particles In A Stationary Fluid, The Drag Co-Efficient In Hindered Settling Compared To That In Free Settling Is -----------?